T56 magnum with Ctsv bellhousing with pump

[BEECHFRONT]

I have a t56 mag with ctsv bellhousing with built in pump, I want to loop a hose so it can circulate rather then block it off, I think the port I use on bellhousing is on passenger side , what port do I use on the t56 trans?

Thanks

[Bigblockscott]

The fitting on the TR6060 bell housing should be low on the passenger side it is the pump discharge. The factory uses a quick connect fitting. You can take the stock fitting out and replace it with a -6AN O-ring straight cut thread adapter like this one from summit: https://www.summitracing.com/parts/sum-220166b
From their you can make a -6 hose and route it to the fill plug on the trans, which is most likely 1/2NPT. If you have the pump, why not run it to a cooler like the factory designed it to?
-6AN to 1/2"NPT adapter: https://www.summitracing.com/parts/v...ion/minus-6-an
Double check what the size of the fill plug is, but I am fairly certain it is 1/2" pipe thread.