Results 1 to 15 of 15
Thread: LS1 GTO ecm rev lock out
Threaded View
-
07-07-2021 #1
Registered User
- Join Date
- Jun 2015
- Location
- home of grits and gnats, SW Ga.
- Posts
- 17
LS1 GTO ecm rev lock out
My 04 gto ecm, afaik pin 44 green connector, goes to ground at low speed or stopped, to energize the lock out solenoid. I'm getting 6k ohms on the ground side with ign on and 12vcd on the other side of the solenoid. Doesn't seem to be close enough to ground to work. Original solenoid seemed stuck when I pulled it out but a few operations on the bench with a battery and it free'd up. I replaced it with new anyway. Any ideas? I don't need it to be the ecm, it's been flashed to work in my 71 vette and everything else works great. But it is an 04 gto motor/ecm. Is 6k ohms normal for the ground output on this pin?
Any help would be appreciated.
-
Reply With Quote
