Another Newbie

[Falcon Daman]

Hi Another newbie here. I noticed that an increasing number of cars in my favorite magazines credit the members and this site in helping with their build. The knowledge base alone was enough to make me want to join, the comunity is icing on the cake.

About my ride.
My main project is a 64 Ford Falcon Sprint 4 speed 260 V8 (well it used to be) I am building it piece by piece as I can save the cash for the parts.
The engine is going to be a 331 stroker based on a ford roller302 block. It will have Trick Flow Twister Wedge heads. Im not yet sure on the cam selection. I currently have an Air Gap manifold and a 650 Street Demon carb but I am considering fuel injection.

I want a 5 speed trans but havent nailed down what kind yet.

Im looking at willwood for the brakes Front and rear. An issue for me is the master cylinder I want power brakes and a dual res master cylinder but there just isnt enough room. Im looking at tilton dual master cylinder setup but im not sure how much fabrication is nessessary.

The global west coil over front end looks good to me. I like the relocated position of the spring to the lower control arm and keeping an eye out for peoples opinion of this setup before I totaly commit to it.

As you can see Im not entirely set on my design yet because every time I find somthing I like, I find somthing that seems better or like it would fit my application better.

Well thanks in advance for any help and I hope to become a regular here.



Thanks again
Daman