Results 1 to 9 of 9
Thread: Smooting 1st gen firewall
-
07-27-2019 #1
Smooting 1st gen firewall
Hey guys and gals,
I'm putting in an aftermarket A/C system and welding/smoothing the firewall where the old heater core was. I was thinking about also smoothing the firewall/cowl seam too. My question is - can I just remove the seam sealer, fully weld the seam and then use metal filler to fill the seam. Maybe a little reinforced filler on top of that. I know lots of others have replaced the whole firewall, but I don't wanna do that major surgery. Any thoughts are greatly appreciated.
Thanks,
David
-
08-01-2019 #2