Results 1 to 20 of 39
-
03-04-2019 #1Registered User
- Join Date
- Oct 2018
- Location
- San Jose, CA
- Posts
- 523
T56 bellhousing alignment - Quicktime
I just wrapped up aligning the Quicktime bellhousing for my T56 Magnum install.
Original measurements we 26 thousands off, so used a 14 dowel from Lakewood oriented to move the bellhousing towards 2PM on a clock.
Which ended up pushing it slightly over in that direction - now sitting at 6 thou off too far towards 2PM.
So either need to shave 2thou off the lakewood pins at the 2PM location, or just leave it.
Tremec spec if .005 so it's within .001" of that.
Parallel axis is another question mark - I'm at .004" out on the top.
so either I need to shim the bottom bolts by .002 or leave that alone too.
Thoughts?1971 Camaro - 406 / T56
2016 Camaro SS convertible
2018 Colorado 4x4
-
03-04-2019 #2