Master cylinder and 9" booster recommendations for '81 Z28 with Kore3...

[68Malibu383]

I have an '81 Z28 that I plan to use for a mix of autocross, open track and street driving. I'm going to install the Kore3 355mm C6 Z06 kit on the front and LS1 brakes on the rear. Tobin recommended a 1" bore M/C with a dual 9" booster with this combo. Looking for M/C and 9" booster recommendations. A factory M/C would be great for availability / cost. Thanks!

[130fe]

Tuff Stuff 9” dual booster and the S10 one (exactly like DSE sells). Works great!

[130fe]

I bought a DSE one a few years ago but here is that great setup. Tuff Stuff 9” dual booster (I used the 2229NC black one) and the S10 one (exactly like DSE sells). Not sure if you need the DSE angle brackets for a second gen. I didn’t use the brake sensor either. Works great!

[68Malibu383]

I bought a DSE one a few years ago but here is that great setup. Tuff Stuff 9” dual booster (I used the 2229NC black one) and the S10 one (exactly like DSE sells). Not sure if you need the DSE angle brackets for a second gen. I didn’t use the brake sensor either. Works great!

Thank you for the suggestions. What brakes do you have?

[130fe]

Thank you for the suggestions. What brakes do you have?

I have the C5 brakes from Kore3 front and rear. I am also running a Wilwood adjustable prop.