ZL1 brembo brake (2012)

[Shotaro]

I would like to install the 2012 Camaro ZL 1 brake on a 1970 Camaro front C4 spindle, rear 12-volt vehicle. Is there a bracket?

[Typhoon1015]

Bigbrakeupgrade.com is who I am working with on a kit for AFX and 12 bolt stuff for CTSV Gen2 units. I know the ZL1 stuff is very close to that (heard of slight offset issues on castings, but cannot confirm). I don't think anyone has done C4 stuff that I have found in my research yet.

[c4racer2]

So you put a full C4 spindle and control arm assembly with coil overs? That's some nice fab work. Seems if you did that you could just fab your own bracket for the calipers?

[Shotaro]

So you put a full C4 spindle and control arm assembly with coil overs? That's some nice fab work. Seems if you did that you could just fab your own bracket for the calipers?

[c4racer2]

nice! Just get the right size rotors for those calipers that are speced for the C4 and figure out where the caliper needs to be and build a bracket to put it there.

[Shotaro]

nice! Just get the right size rotors for those calipers that are speced for the C4 and figure out where the caliper needs to be and build a bracket to put it there.

I am thinking very much. THX

[CSG]

Be diligent in your design work if going that route. When I was 15 I ripped two poorly executed caliper brackets off the car standing on the brakes at 100 trail braking into a turn in a light car on DOT tires.

[c4racer2]

ooo - that's a bad day...

[Shotaro]

[andrewb70]

Details?

Andrew

[Tpichevy]

Following excitedly