-4an 2in wide through frame fitting

[Chuck0379]

Does anyone make these? I’m running -4 from the master cylinderr to the rear on my 68 Camaro and would like to use a -4 frame through fitting but can’t find one anywhere. I’ve found small ones about 1” wide by aueroquip. What are my options?

Thanks,
Chuck

[BBPanel]

https://www.inlinetube.com/pages/pro...emNumber=thf02 I think this is -3, I'd check with them to verify and if they have same in -4. If you want -4 or -3 on both sides you could run and adapter on the female threaded side.

[Chuck0379]

Thanks. I’ll check it out.

[dontlifttoshift]

Don't run -4 to the rear.

If you are already committed, run -4 to any of the through frame fittings you have already found, install 1/8 npt x -4 adapter on the NPT side and then run -3 on the male outlet.

[Chuck0379]

I’ve heard mixed reviews about running -3 or -4, but -4 is what I already have/factory and works good. Just installed a new 4 link so figured I’d keep it the same. What difference would there be if I ran -3?

[dontlifttoshift]

The biggest difference is that you can buy a fitting that does what you need it to do.