Pro-touring 72 Camaro SS

[limpsilver]

What do you do for passenger seat?

[berdunord]

Front passenger seat is the same as the driver one, rear I dont know for the moment, maybe a blackTMI cover

[limpsilver]

OK, I only saw one seat on the photo. Some people only change the driver's seat, but changing both looks really nicer!

[berdunord]

[berdunord]

[berdunord]

big brother is here now, let's go to 1000hp

[berdunord]

received about 90% of all parts, I will be able to begin the engine swap, finish the roll cage and begin to install the ISIS multiplex system

[Gil]

Cool ! Now I know where goes Alex motor.
Congratz and keep up the good work!
Gil

[berdunord]

Merci camarade !

[berdunord]

[berdunord]

new 35 spline wavetrac diff with race ready gear and pinion and 35/33 splines axles 300M material, really nice parts from Dutchman Axles !!!

[berdunord]

Speedway Engineering custom 3-piece splined sway bar recived, everything with 4130 chromoly material and heat treated, really nice job !!

[berdunord]

new lifters from Lunati, a 720lph fuel pump and all hardware to install the 3-piece splined sway bar received. awaiting for a road racing oil pan and the Bowler T56 oil pump.

[berdunord]

lifters changed, rev kit installed and oil pan ready to be installed after tig-welding the turbo return line bungs

[berdunord]

some picts of the short bloc, a Cola cranshaft COLS348A SI824, forged piston and forged H-Beam rods, billet timing chain and main caps everything with ARP blots.

Moroso road racing oil pan installed, way better than my street strip oil pan that was too deep for a pro-touring car, I will finally be able to lower the car again 1/2 inch.

And to add rigigity to the chassis I will weld 4 tubes from the motor crosmember to the rear front-subframe and from that tube to the lower control arm bracket.

next step is weldings tubes from the firewall to the front subframe and building the 3-piece splined sway bar.

I don't care about weight, this will be a 1000hp street car, I want it as stiff as possible.

[Motown 454]

Nice!

[berdunord]

thx ! cutting of firewall brackets to weld the down tube braces with domex 700 maaterial

[berdunord]

[berdunord]

[berdunord]