Results 41 to 60 of 583
Thread: Pro-touring 72 Camaro SS
-
03-14-2017 #41Registered User
- Join Date
- Oct 2016
- Posts
- 556
-
03-17-2017 #42Registered User- Join Date
- Oct 2016
- Posts
- 556
03-19-2017 #43Registered User- Join Date
- Oct 2016
- Posts
- 556
03-26-2017 #44Registered User- Join Date
- Oct 2016
- Posts
- 556
awaiting for the exhaust line, I've finished several things, a bracket to hold the MAP sensor, an other to hold the turbo feed line not to touch the exhaust line, flex fuel connector and coil brackets received, I think I will be able to put them on the valve cover, I will have to build a weird exhaust line on driver side but it should let enought room for the coils.
front end heighten about 1/2" to be at the same height as rear end and because the oil pan is a bit lower than the motor crossmember, 25.6" from ground to inner fender, if french roads were not full of speed bumpers, the car would be 1" lower....
04-08-2017 #45Registered User- Join Date
- Oct 2016
- Posts
- 556
Finallly the coils will be on the front of the inner fender, I've ordered Granatelli coils and custom length 0 ohm spark plug wires and I've decided to relocate the battery in the trunk so I will be able to put the air filters far from heat, with simple items found in a home depot, I've made an air duct integrated in the front spoiler, and cut the passenger side inner fender to let some room for the intercooler pipe, still some work to make it clean but it will look good when it will be finished.
04-09-2017 #46Registered User- Join Date
- Oct 2016
- Posts
- 556
04-10-2017 #47Registered User- Join Date
- Oct 2016
- Posts
- 556
04-11-2017 #48Registered User- Join Date
- Oct 2016
- Posts
- 556
04-12-2017 #49Registered User- Join Date
- Oct 2016
- Posts
- 556
04-13-2017 #50Registered User- Join Date
- Oct 2016
- Posts
- 556
04-15-2017 #51Registered User- Join Date
- Oct 2016
- Posts
- 556
04-15-2017 #52