Attachment 183612
Coated the charge pipes
Oil lines ran and scavenge pump done
Wastegate plumbing done
Heat barrier on the floor
Printable View
Attachment 183612
Coated the charge pipes
Oil lines ran and scavenge pump done
Wastegate plumbing done
Heat barrier on the floor
Attachment 183697Attachment 183698Attachment 183699Attachment 183700Attachment 183701Attachment 183702Attachment 183703Attachment 183704Attachment 183705Attachment 183706Attachment 183728
Truck is finally finished and waiting to go to get dyno tuned. Couldn’t be happier.
Bravo, sir! The truck is coming together nicely. Cant wait to see some action shots.
Attachment 184001
I was wiring the flex fuel sensor and got another pic of the engine. I’m very happy with how it turned out. It’s in the trailer ready for the dyno. Just waiting to drop it off. Thanks everyone for the comments I appreciate it
Attachment 184432
Finally got it back from the dyno, not too bad
640whp
Awesome job!! Thats a pretty good bump..what does the seat of the pants dyno say?
Scary as hell it’s like a completely different truck, it drives like it use to till you hit 3000-3500.
I like getting on the freeway in 3rd and 4th and just rolling into it. That’s my favorite. It just pulls so hard!
Totally happy with it. We had the make some changes to the scavenge system. I will update with pics when I do that. Gathering parts. Thanks everyone!!!!
Wow this truck just keeps getting better and better. There isn’t anything about this truck I would change.
What are you using as pass-throughs on the truck bed above?
Wanted to say you have a great looking Truck! Nice Build! What modifications if any did you have to do to the floor pan around the Tunnel area or rear of the Tunnel to fit the transmission? Please let me know. Pulling parts together for a 68 C10 I'm working on.
Thank you! I appreciate it.
We just installed a high hump in the floor with no other modifications other than a little massaging to one of the ends. It was a GM reproduction piece for 4wd trucks I believe. You should already have the line stamped in the floor to cut. We installed some nut-certs and that’s what’s holding it in. I’m however going to be putting some silicon down to completely seal it.
Here’s the link to the exact one I got
https://www.brotherstrucks.com/1967-...tinfo/HHC6772/
Good luck on your build!
Dude, again Nice Build! Thanks for the link.
Amazing build. Nice job! Would love to see it in action.
Very cool build...I am not sure how I missed it before...
Andrew