I've finally got my hot and cold sides fabricated. Any good recommendations for a local shop for ceramic coating work here in SoCal, preferably in the Inland Empire?
Attachment 155635Attachment 155636
Printable View
I've finally got my hot and cold sides fabricated. Any good recommendations for a local shop for ceramic coating work here in SoCal, preferably in the Inland Empire?
Attachment 155635Attachment 155636
Embee in Santa Ana. Nice job on your car too.
Thank you!
Looks great!
Try Young Guns in Rancho Cucamonga for coatings
Nice build! I’m building the same thing 69 with twin turbos what size engine and turbo?
Thanks! Motor is a 383 with Dart Pro 1 heads and FAST efi. Turbos are Turbonetics T04B (60mm) and running a two-stage boost controller. I plan to run street trim around 8-10 psi and my track tune is 15 psi. Made about 750HP/750tq prior to reworking the hot side to flow better, I anticipate putting down around 800 which is about as much I want to throw at the original GM block but should be enough power for the street. How about you?
looks good, I'm about to start my hot and cold side plumbing.
That's really nice I wish I had the skills to do that fab work...
Looks good. Curious on your plan surrounding the brake booster / master. Piping looks a tad tight back there.
Yes the downpipe interferes with the stock location. Putting in a reverse swing mounted Wilwood setup with the master cylinder inside the car with a remote fluid reservoir located on the firewall. Brakes are Wilwood four pot on all corners and currently manual. In the future I might consider going with a hydra boost if I can make it fit.