LOL!
Thanks!
Pat
- - - Updated - - -
Thank you!
Printable View
Looking great, Pat! Did you use the rubber gasket between the tank and the fuel pump module? I found that those rubber gaskets swell very quickly when exposed to pump gas. I ended up using the cork gasket with Permatex aviation sealer, which has held up much better.
Andrew
Engine is installed (I hope for the last time;-)
Thanks
Pat
https://static1.pt-content.com/image...502722C3-1.jpgimages free hosting
https://static1.pt-content.com/image...2DD70CE0-1.jpg
https://static1.pt-content.com/image...C64F6E6D-1.jpgupload picture without account
https://static1.pt-content.com/image...F6B5F84D-1.jpg
https://static1.pt-content.com/image...4D1D1BA4-1.jpg
https://static1.pt-content.com/image...F6C0C6EC-1.jpgpic upload
Congratulations! That’s a big step out of the way. Glad it went well.
Lookin' good. :)
^^^^Like
Congratulations on the engine install and all the other wonderful progress. I wish I had 1% of the skill you display!
Thanks Pat! I was going to do the same but will go with a Rick's Restomod tank with a Gen 5 Camaro SS fuel module now... sometimes it's nice have a 2nd gen F-body.
Looking great Pat! been drooling over your build for years over on DC.com - I am getting ready to start a MS3 project on my 6.1 swapped 68.... Love the detail on the entire build
Thank you! Good luck with your build!
pat
- - - Updated - - -
Moving along with a few projects! All the fuel, AC, and Hydroboost lines hooked up! Trans cross member and shifter is installed.
Thanks
Pat
https://static1.pt-content.com/image...DFCC9920-1.jpg
https://static1.pt-content.com/image...1BC4BDE6-1.jpg
https://static1.pt-content.com/image...E94B2FC6-1.jpgi want you forever
https://static1.pt-content.com/image...843DF30F-1.jpg
https://static1.pt-content.com/image...FB68972C-1.jpg
https://static1.pt-content.com/image...22AE4272-1.jpgphotoupload
https://static1.pt-content.com/image...CB7059AD-1.jpgpic sharing
https://static1.pt-content.com/image...34CE7AAC-1.jpg
This build is just amazing. The twin throttle bodies look badass/nostalgic on the modern hemi
Are you going to fire it before you finish assembly?