How to remove dents from frame?

[65 drop top]

What is the best way to remove some some dents from my '55 chevy frame? It is a boxed frame. The dents are not very deep or sharp, most likely caused from jacking up the car. The body is off the frame so I can flip the frame over to work on it. Thanks for any info.

[Shootstraight]

Hard to say without seeing them, I'm trying to figure out how they dented from a lift (unless its weak from rust). If you can get inside then there are tools that will help but if not about the only thing I know of is tiger hair filler. If their bad and deep then sometimes that means cutting out that section and straightening it then welding it back in.

[BobK]

You could try using a stud gun to weld studs to the low spot and pull them with a dent puller. If the material was thin enough to dent in the first place, if may come back up with the studs. If not, fill them as noted above.