EFI69Cam
08-12-2005, 09:05 AM
Further issues with the POS kit I bought from K@#$%^)r.
The trans seems to be at more of a down angle than I need. I seem to recall that proper angle is achieved when the trans mainshaft is parallel with the subframe rails. Is this correct?
I think I might have to cut the crossmember and move the center of it up about 3/8" to 1/2" floor clearance is not a problem as I have raised the trans tunnel.
The trans seems to be at more of a down angle than I need. I seem to recall that proper angle is achieved when the trans mainshaft is parallel with the subframe rails. Is this correct?
I think I might have to cut the crossmember and move the center of it up about 3/8" to 1/2" floor clearance is not a problem as I have raised the trans tunnel.