heynow14
08-30-2012, 10:50 AM
Hey guys -
I've got my new VWW 17x9.5s installed on rear with 275s. Not surprisingly, it's far too tight, so I need to roll lips on four corners. I'm looking at renting the Eastwood fender roller tool versus baseball bat, etc. Or getting somebody out to do it. What else have you done to do a nice job of rolling knowing you want to save nice paint? I need to pick up a good bit lot of room so perhaps I'm cutting AND rolling.
Anybody recommended in SoCal area I can trust who does early iron and not just ricer imports?
Thoughts?
I've got my new VWW 17x9.5s installed on rear with 275s. Not surprisingly, it's far too tight, so I need to roll lips on four corners. I'm looking at renting the Eastwood fender roller tool versus baseball bat, etc. Or getting somebody out to do it. What else have you done to do a nice job of rolling knowing you want to save nice paint? I need to pick up a good bit lot of room so perhaps I'm cutting AND rolling.
Anybody recommended in SoCal area I can trust who does early iron and not just ricer imports?
Thoughts?