PDA

View Full Version : Build a box for my 69 chevelle



tuc_240
08-18-2012, 10:33 PM
Nothing to fancy, but i wanted some trunk for tools and groceries.

Here are the plans i drew up.

This should fit any A-Body from 68-72 seeing as they have the same trunk floor.

Enjoy

PT Sportwagon
08-20-2012, 07:48 AM
I would actually go for a full sheet brace cut out. If your read the notes on bracing on the JL web site. you can never have too much. Even just using W0s.

Tim

67rally
08-20-2012, 10:04 AM
I would actually go for a full sheet brace cut out. If your read the notes on bracing on the JL web site. you can never have too much. Even just using W0s.

Tim

He already built it, so it's a little late to change the bracing now.

I agree on the full brace, but you can also add a ton of strength and save some weight by using a full sheet and then cutting out a bunch 3-6" circles if you aren't trying to seal the left and right chambers from each other.

tuc_240
08-20-2012, 04:37 PM
Yeah i was thinking of bracing it with a full center section and routing out an upper area and lower area with a 2 in wall left in the center, top and bottom.

I dont see any flex but im sure there is a little. It sounds great though.