SatisTraction
06-30-2005, 04:47 PM
ok, I have been reading up and i know i need about a 2.5 degree down angle on the tranny and a 2.5 degree up angle on the rear yoke to prevent drive line vibrations. my question is what do i reference the angle to?
I was planning to put the car on stands and get the front frame rail (under the floor pans) perfectly level and then giving the engine the 2.5* down.
The rear is still in the building phase so it will come later.
anyone got a better idea?
thanks
chris
I was planning to put the car on stands and get the front frame rail (under the floor pans) perfectly level and then giving the engine the 2.5* down.
The rear is still in the building phase so it will come later.
anyone got a better idea?
thanks
chris