all wired
04-18-2011, 08:41 AM
Bought these injectors for my current project, but it turns out they're too big. They have minimal run time and a few dyno passes on them.
Here are the specs:
Coil Resistance: 2 Ohms / Low Impedance
Static Flow Rate @ 43.5PSI ( 300kPa ) w/Gas: 1000 cc/min = 96 lb/hr = 12 gm/s
Connector: Bosch EV1
Ball & Seat / Disc design with 6 Hole orifice
9.6-18v
Set point 2.5 ms @300 kpa (43.5lbs)
I'm asking $350 or best offer for them, but Im open to trading for a set of 68 - 72lb injectors of same condition.
Please PM me or email to: [email protected] with any questions
46087
46088
46089
Here are the specs:
Coil Resistance: 2 Ohms / Low Impedance
Static Flow Rate @ 43.5PSI ( 300kPa ) w/Gas: 1000 cc/min = 96 lb/hr = 12 gm/s
Connector: Bosch EV1
Ball & Seat / Disc design with 6 Hole orifice
9.6-18v
Set point 2.5 ms @300 kpa (43.5lbs)
I'm asking $350 or best offer for them, but Im open to trading for a set of 68 - 72lb injectors of same condition.
Please PM me or email to: [email protected] with any questions
46087
46088
46089