AintQik
02-24-2011, 11:11 AM
Can some of you 1geners with agressive stances take some rear end measurements for me? I'm going with a new set up and want to get some references.
Center of axle to top of wheel arch
Top of diff housing to trunk floor (straight up from top of pumpkin till it makes contact)
Yoke to tunnel clearance
Indicate if weight on or off car.
Obviously these cars are vastly different and just want to get a ball park of where the housing will sit, or where it should sit on a PT stanced car.
If you have a pic of your car at ride height that might help for reference as well. I know I'm asking a lot, but this may be a good reference for others as well. I'm concerend about my travel at ride height, so I'd like some comparison data. Starting from scratch, options are only limited to my pocket.
Many, many thanks if any of you have this.
Center of axle to top of wheel arch
Top of diff housing to trunk floor (straight up from top of pumpkin till it makes contact)
Yoke to tunnel clearance
Indicate if weight on or off car.
Obviously these cars are vastly different and just want to get a ball park of where the housing will sit, or where it should sit on a PT stanced car.
If you have a pic of your car at ride height that might help for reference as well. I know I'm asking a lot, but this may be a good reference for others as well. I'm concerend about my travel at ride height, so I'd like some comparison data. Starting from scratch, options are only limited to my pocket.
Many, many thanks if any of you have this.