Bow Tie 67
08-05-2010, 12:33 PM
http://www.circletrack.com/drivetraintech/ctrp_0803_bearing_maitenance/technology.html
The article above shows setting up the spindle at .001 bearing axial freeplay. This is checked with no grease and no inner seal. My question is, do you think this maybe to tight for an aluminum hub?
Also, I'm looking for recommendations on good high performance grease.
The article above shows setting up the spindle at .001 bearing axial freeplay. This is checked with no grease and no inner seal. My question is, do you think this maybe to tight for an aluminum hub?
Also, I'm looking for recommendations on good high performance grease.