PDA

View Full Version : Rechromer



Bill Howell
05-10-2005, 10:51 AM
Any suggestions/recommondations for a good rechromer in the southeast. I have some trim pieces on the Lemans that need some attention and being able to find replacements isn't looking too good. Most of the stuff is potmetal.
Thanks

Bad Bowtie
05-10-2005, 05:11 PM
Bill,
You might want to check out these people http://www.advancedplating.com
They are in Tennessee too. If I remember right I think they were at our Turkey Rod Run in Daytona this past year and they do potmetal work also. I haven't used them so I dont have an opinion on their work, but some of their samples looked very good.
Jack

Bill Howell
05-10-2005, 05:14 PM
Thanks Jack,
I had their card but lost it. I knew there was a place in Nashville, and could not find their info.
Thanks again,