Schwartz TT LS7 68 Camaro

[jeff s]

A full chassis and LS7 with a pair of Turbonetics GTK850's.
The engine has been dyno tested, we're now fabbing the system to fit the car.
Should be running and driving in 3 more weeks.
More pics on our site, link is below.

Thanks

[Mr.VENGEANCE]

raw..

i bet it took some convincing.. i heard the ls7 doesnt like boost.

[Bow Tie 67]

Jeff,

Any plans on bringing it to RTTH 5 ?

[frankenstang]

Swap the rods and lower the compression with custom pistons. Keep the boost under 18 pounds and it's fine. Jeff had this figured out 2 yrs ago on the LS7. The car is gonna be an animal for sure. I'm not sure if this engine got the same treatment, but there's an Ultima GTR running around Prague with over 1000hp with a twin turbo LS7.

[andrewb70]

raw..

i bet it took some convincing.. i heard the ls7 doesnt like boost.

I believe this LS7 has forged internals.

Andrew

[PhillipM]

Jeff,

When we spoke about this project on Power Tour I know you were a little questionable about fitting it all in there. Looks like you have gotten a majority of the desgin work done. Nice job.

[jackfrost]

to hell with restraint. :razz:

[frankenstang]

Some of us REFUSE to participate in a 'recession' I just ordered my PLX wideband and am getting ready to install a new Abaco MAF on my 91 Mustang.

You are right, to hell with restraint.

[jeff s]

More pics here:
http://www.schwartzperformance.com/projects.aspx?projectid=28

[1971CHEVELLE]

looking very good

[jeff s]

We built the engine, dynoed, installed it, fabbed turbo system and exhaust. It has one of our muscle up full frames under it. The customer is building the car, it should be in PHR soon in the "Under Construction"
It's now back in Georgia for final details.
Videos:
http://www.youtube.com/watch?v=QNqevQxT_Bk&NR=1
http://www.youtube.com/watch?v=hkFCzq013Kg

First drive
http://www.youtube.com/watch?v=gbijoTXn2yc