ProTour69Bird
05-01-2009, 06:02 PM
i'm far from doing this but i think it would look crip
has anyone done this before, could you just weld in a piece of box tubing to the ends of the frame rails to take the blow if the unthinkable rear ender bender happened?
how hard would it be to flush the rear roll panel to the tail light panel, and eliminate the bumper tabs on the side, maybe not all flushed out.
i was just thinkin about this one day eyeballin over my car, and actually found a vid, that shows a glimpse, and i mean Glimpse of it
i think it would be a clean modern look to the already beautiful ass end
check deez out
http://www.youtube.com/watch?v=NdPhVRK5YCg
http://www.youtube.com/watch?v=anl2rP21bMU
love it!
has anyone done this before, could you just weld in a piece of box tubing to the ends of the frame rails to take the blow if the unthinkable rear ender bender happened?
how hard would it be to flush the rear roll panel to the tail light panel, and eliminate the bumper tabs on the side, maybe not all flushed out.
i was just thinkin about this one day eyeballin over my car, and actually found a vid, that shows a glimpse, and i mean Glimpse of it
i think it would be a clean modern look to the already beautiful ass end
check deez out
http://www.youtube.com/watch?v=NdPhVRK5YCg
http://www.youtube.com/watch?v=anl2rP21bMU
love it!