TMat
03-26-2009, 12:36 PM
I have a new MSD e-curve distributor. In the directions it says to only use the 2 o-rings at the bottom of the shaft if the block has been chamfered where the o-rings and block meet. I have always used the o-rings and never chamfered those edges.
instructions here http://msdignition.com/instructions/Products/Distributors/8394.pdf?terms=e-curve Page 5
Do I use the o-rings or not?
instructions here http://msdignition.com/instructions/Products/Distributors/8394.pdf?terms=e-curve Page 5
Do I use the o-rings or not?