View Full Version : Fabrication Shop in the Northern VA/MD/DC Area?
Bulletpruf
02-25-2009, 05:42 AM
Fellas -
Need some welding done - want to install a cage and subframe connectors in my 71 Javelin Trans Am clone. Would also like to have someone fab up a dash - nothing fancy, just aluminum with gauges. Any recommendations on a shop in/around Northern VA/MD/DC? I don't mind driving a bit, if necessary.
Thanks!
Scott
Moose
02-25-2009, 05:49 AM
I have used a place called performance auto fab. He is very good fab guy and better welder. A little pricey, but good. He is off of the 695 beltway near baltimore. http://www.performanceautofab.com/
there is also autofab near laurel. Very good as well. http://autofabcart.net/
recommend both places. First one I've had first hand expierence with.
SicMonte
02-25-2009, 08:13 AM
you could always go up to G Force Design Concepts. They are about 30 minutes north of Hagerstown.
Bulletpruf
02-26-2009, 03:20 AM
you could always go up to G Force Design Concepts. They are about 30 minutes north of Hagerstown.
Not sure I can afford G Force, but I did e mail them. Love that Demon!
Thanks,
Scott
Bulletpruf
02-26-2009, 03:21 AM
I have used a place called performance auto fab. He is very good fab guy and better welder. A little pricey, but good. He is off of the 695 beltway near baltimore. http://www.performanceautofab.com/
there is also autofab near laurel. Very good as well. http://autofabcart.net/
recommend both places. First one I've had first hand expierence with.
Checked both websites - look like quality shops.
Thanks,
Scott
Bulletpruf
02-26-2009, 11:32 AM
Folks at G Force are quite prompt and helpful. Waiting on price quotes.
Thanks,
Scott
Powered by vBulletin®