LS Engine bay wiring

[67 ls1 vert]

Hey gang, I have a LS engine that is going in a 67 Camaro.
I want to run my main wiring loom from my engine to the inside of my car and dont want it to be visable at all. I have a smooth firewall and dont want to cut it in the wrong place.

Where did you guys run it throught the firewall at? I was thinking above the Trans tunnel.

Does the loom have to be extended to get the computer to fit underneeth the dash?

Does anyone have any good pictures? :)

Thanks.

[Bow Tie 67]

I did this without extend the harness, I opened it up and changed the routing. I can get you some pics in the next couple of days.

View from Passenger side interior

https://static1.pt-content.com/images/noimg.gif (http://good-times.webshots.com/photo/2074124990065608932xYiSnH)

View from passenger side engine bay

https://static1.pt-content.com/images/noimg.gif (http://good-times.webshots.com/photo/2722803840065608932sMbqzS)

[67 ls1 vert]

Thanks, thats what I was looking for. It looks like you have it on the floor board in front of the console?? What do you do to hide it, or does show? I would like to see more pictures when you can upload them.

[Bow Tie 67]

Yes its on the trans tunnel under the dash. The car is far from finished, and yes it is visible at this point. I have kicked around ideas of a custom console that will hide it.

[67 ls1 vert]

any others?