Turbo67camaro
07-04-2008, 11:32 AM
My builder assembled my front end, did a wheel measurement, and then diassembled the car for paint, before I could measure it myself.
I'd like to use 18 x 8 Livewire's in front (although, I haven't ruled out Superspoke's).
I'm skeptical if the measurement was accurate (2" from rotor outward - leaves 6" backspace).
Anyone running this combination (or close to it) and know their backspace or offset measurements ?
67 Camaro
SPC upper and lower arms
stock subframe
ATS AFX tall spindles
C6 PBR brakes using DBA-4000 rotors from Kore3I was expecting a backspace in the 4.5 to 5" range.
I have Jon's recommendation from DriverzInc and I respect that. However, it is my responsibility to get it right, not Jon's or my builders.
Thanks,
Mike
I'd like to use 18 x 8 Livewire's in front (although, I haven't ruled out Superspoke's).
I'm skeptical if the measurement was accurate (2" from rotor outward - leaves 6" backspace).
Anyone running this combination (or close to it) and know their backspace or offset measurements ?
67 Camaro
SPC upper and lower arms
stock subframe
ATS AFX tall spindles
C6 PBR brakes using DBA-4000 rotors from Kore3I was expecting a backspace in the 4.5 to 5" range.
I have Jon's recommendation from DriverzInc and I respect that. However, it is my responsibility to get it right, not Jon's or my builders.
Thanks,
Mike