02somz28
07-01-2008, 09:49 PM
Finally time to post the introduction. HAve a garage full of cars, with the most pressing project being a 65 Mustang Coupe. One owner 6 cylider three speed bench seat car my wife bought.
Driveline and interior have been removed in preparation for a modern driveline and suspension. HAve a '93 5.0 complete with harnesses and computer as a starting point. Looking at options for a 6-speed, and always on the lookout for the killer deal for a 4.6 DOHC 6 Speed driveline.
At this point, trying to decide on the following:
1. Front suspension. The shock towers have to go. Looking at Mustang II style but cannot decide on who's. So far have looked at FatMan Fab and Heidts.
2. Rear suspension - CA/TCI has a sweet setup, but 5K is a lot to spend. Have several leads on Cobra IRS units, but that would lead to item 3.
3. How to flare the rear fenders in steel. Trying to do as much work as possible in the garage. While I am good with fiberglass, I really want to do steel. I have not found anyone near houston that will flare the fenders in the style of the old SCCA Trans AM cars. SN65.com has a "kit", but I have not seen any installed, except for the set they installed on their car.
Trying to build a quality platform, with an eye on road handling and performance. Exterior color shoice will be Orange, as are most of our vehicles. Build will be at the house in a 4 car garage with 4 post lift sharing space with
2002 SOM Z28
1989 Mustang GT (Son's ride)
2003 SOM Magnacharged Avalanche Z66
2007 Dodge Ram (Son's DD)
1993 Buick Roadmasher (Daily Driver)
Driveline and interior have been removed in preparation for a modern driveline and suspension. HAve a '93 5.0 complete with harnesses and computer as a starting point. Looking at options for a 6-speed, and always on the lookout for the killer deal for a 4.6 DOHC 6 Speed driveline.
At this point, trying to decide on the following:
1. Front suspension. The shock towers have to go. Looking at Mustang II style but cannot decide on who's. So far have looked at FatMan Fab and Heidts.
2. Rear suspension - CA/TCI has a sweet setup, but 5K is a lot to spend. Have several leads on Cobra IRS units, but that would lead to item 3.
3. How to flare the rear fenders in steel. Trying to do as much work as possible in the garage. While I am good with fiberglass, I really want to do steel. I have not found anyone near houston that will flare the fenders in the style of the old SCCA Trans AM cars. SN65.com has a "kit", but I have not seen any installed, except for the set they installed on their car.
Trying to build a quality platform, with an eye on road handling and performance. Exterior color shoice will be Orange, as are most of our vehicles. Build will be at the house in a 4 car garage with 4 post lift sharing space with
2002 SOM Z28
1989 Mustang GT (Son's ride)
2003 SOM Magnacharged Avalanche Z66
2007 Dodge Ram (Son's DD)
1993 Buick Roadmasher (Daily Driver)