View Full Version : This is what I am working on

02-09-2005, 02:33 PM
Here is my project.

02-09-2005, 03:32 PM
Looks good. Are actual air bags or helper bags? Looks like normal springs outside the bags.

02-09-2005, 05:16 PM
They are helper bags.
I also added some other pics to view other areas.

02-09-2005, 05:35 PM
Very nice!

02-09-2005, 05:56 PM
looks good, I'm in about the same spot right now, but don't have any pictures...
What are the specs on your big block? What kind of radiator/fan setup did you go with?

02-09-2005, 06:12 PM
Hey Thanks For Asking,
The Motor Is The Original 396(402). It Was Bored .030 Over With Forged Pistons( About 10.25 To 1). The Heads Are Off Of A Ls-6. They Were Ported With The 3 Angle Vave Job. The Cam Is The 294 Comp Extreme Roller, Comp 1.7 Rollers. And The Intake Is Edelbrock Rpm Air Gap And A Holley 750 Or A 780.
As Far As The Acces. Go I Want To Get The Serp. Set Up.

The Rad. Is From A Local Shop. And I Got The Fans Off Of A Nissan Altima. It Fit Perfectly.
Now I Just Hope To Get Everything Else Going!

Steve Chryssos
02-10-2005, 05:46 AM
Looks awesome. The helper bags seem a good idea. Figure out wheels & tires yet?

02-11-2005, 05:08 AM
I am looking at running these in 18's.These are the new Billet Specialties.