This is what I am working on

[protouring70]

Here is my project.
Brent

[Conekiller13]

Looks good. Are actual air bags or helper bags? Looks like normal springs outside the bags.

[protouring70]

They are helper bags.
I also added some other pics to view other areas.

[rocketrod]

Very nice!

[4FTTY4]

looks good, I'm in about the same spot right now, but don't have any pictures...
What are the specs on your big block? What kind of radiator/fan setup did you go with?
Nick

[protouring70]

Hey Thanks For Asking,
The Motor Is The Original 396(402). It Was Bored .030 Over With Forged Pistons( About 10.25 To 1). The Heads Are Off Of A Ls-6. They Were Ported With The 3 Angle Vave Job. The Cam Is The 294 Comp Extreme Roller, Comp 1.7 Rollers. And The Intake Is Edelbrock Rpm Air Gap And A Holley 750 Or A 780.
As Far As The Acces. Go I Want To Get The Serp. Set Up.

The Rad. Is From A Local Shop. And I Got The Fans Off Of A Nissan Altima. It Fit Perfectly.
Now I Just Hope To Get Everything Else Going!
Brent

[Steve Chryssos]

Looks awesome. The helper bags seem a good idea. Figure out wheels & tires yet?

[protouring70]

I am looking at running these in 18's.These are the new Billet Specialties.