David Pozzi
04-06-2008, 09:10 PM
Any tips for sharpening tool bits?
I did some fly cutting of cast Magnesium today and the finish was not as nice as the aluminum I practiced on. Should the tool bit for mag have more angle than an aluminum bit? I'm going to do some reading up on it but would like to hear any tips you may have.
Thanks, David
I did some fly cutting of cast Magnesium today and the finish was not as nice as the aluminum I practiced on. Should the tool bit for mag have more angle than an aluminum bit? I'm going to do some reading up on it but would like to hear any tips you may have.
Thanks, David