Does $750.00 For Driveshaft Sound Right?

[sharp67]

Called 2 Different Shops. Inland And Nw Drivelines NW Both Quoted About The Same. 3 1/2 Diameter Aluminum, 1350 Joints On Both Ends. C6 31 Spline Quick Release Tranny Yoke, Forged Pinion Yoke For 10". Does This Sound Right? Just Seams A Bit Pricey. Thanks For The Feedback. I Am Open To Other Shops If They Can Ship To Tacoma Wa Area. Any Recomendations?

[John McIntire]

That sounds about right, maybe a little high.
You might want to try Denny's
www.dennysdriveshaft.com (http://www.dennysdriveshaft.com)
thats where i got mine, pretty good warranty too!

[hotrdblder]

local driveshaft shops can do shafts also with same parts, i had just a shaft made with 1350 ends for a 68 camaro 3.5 inch for 210.00 bucks
jake

[willieboy240]

700 for aluminum thats just a little high but not by much. 210 for steel. thats what they get for one around here in california.

[69HuggrrrPT]

Try shaftmasters.com I think there about $300, not sure about the yoke being forged though.

[PT Goat]

I don't have a breakdown (it was a package deal from CC5S), but that's the exact same driveshaft that Inland built for me in 12/05. I don't remember it being anywhere near that much...

$350 sticks in my head, but the could have been the upgrade cost.