how do you make the measurement for a drive shaft?
andrewb70
01-17-2005, 05:51 PM
http://www.dennysdriveshaft.com/html/how_to_measure.html
Andrew
will69camaro
01-17-2005, 08:31 PM
All i did was make sure the weight was on the axle and the car was level...Then i took my driveshaft that was too short and put it all the way in the transmission (T56 trans) and then pulled it out 1 inch and measured from the center of the two u-joints...Came out EXACTLY right for my application.
William