PDA

View Full Version : 73 Nova Guldstrand Mod Questions



wheelgunner
11-10-2007, 07:51 AM
I tried a search for 73 Nova Guldstrand Mod and I came up empty. I've been spending hours on this site and I'm a little confused:hammer:

Is the Guldstrand Mod template for 67-69 Camaro the correct one to use for 73 nova with stock A-arms?

I am looking at the link from Pozziracing.com
http://www.pozziracing.com/first_gen_suspension_geome.htm#Re-located%20upper%20mount (http://www.pozziracing.com/first_gen_suspension_geome.htm#Re-located%20upper%20mount)

Thanks.

Dan

Lowend
11-10-2007, 09:15 AM
That is the correct template

Project69
11-10-2007, 11:23 AM
How would i print that out to exact size needed? Ive been trying to do this but couldnt find the template for it.

David Pozzi
11-10-2007, 09:34 PM
Print out the template on my web page, it's a .jpg image. If it's too large or small, then change your print size setting.
The main thing is to have the template width the same as your A arm hole spacing or the A arm won't fit over the studs.

The template is available from Guldstrand, but the same problem exists, you need to verify the hole spacing since these templates get photocopied and that can enlarge or shrink it a bit.
David
David

Project69
11-11-2007, 02:22 PM
and height? How low should the lower bolt holes be in relation to the factory?

68Formula
11-12-2007, 12:30 AM
and height? How low should the lower bolt holes be in relation to the factory?

Irrelevant if you use the template as instructed with the confirmed hole spacing. Just make sure they the template has the 6.5" spacing. Not only are the holes lower, but more rearward for increasing the caster.