Need the lines from m/c to prop block. [Archive]

View Full Version : Need the lines from m/c to prop block.

Rileys68Camaro

11-02-2007, 06:27 PM

I need the short lines that connect the master cylinder to the distibution block and can't find them. Any ideas, I'd rather not fab them as I don't have the tools.

Using the 1" non power Corvette master cylinder from Touring Classics and the SSBC prop block that is a combo distribution block and proportioning valve.

Thanks!

MrQuick

11-02-2007, 08:17 PM

where are you?

Rileys68Camaro

11-03-2007, 08:54 AM

I'm in Southeast Idaho

Hammered

11-03-2007, 01:03 PM

I fabbed some mock-ups out of copper and sent them to www.rightstuffdetailing.com which duplicated them in SS. Price was very reasonable.