jc70chevy
07-10-2007, 02:05 PM
hi my names jc i have a small block 355 in my camaro aluminum heads solid roller cam and a 4 speed . my ??? was can i run a tpi set up on this motor and produce the same power . the reason asking is that a have on sitting in the garage was going to throw it in my datsun240z but i drive my camaro more and the camarois more fun so i was wondering any advice thanks
camcojb
07-10-2007, 03:54 PM
hi my names jc i have a small block 355 in my camaro aluminum heads solid roller cam and a 4 speed . my ??? was can i run a tpi set up on this motor and produce the same power . the reason asking is that a have on sitting in the garage was going to throw it in my datsun240z but i drive my camaro more and the camarois more fun so i was wondering any advice thanks
probably not, at least not up top. The TPI setup is basically done by 4500-5000 rpms, and depending on your solid roller that likely won't match up very well. It will be responsive but no top end, and I doubt you'd be happy with it.
Jody