Camaro Zach
11-08-2006, 11:44 PM
so i'm sure some of you remember the dune buggy a friend of mine and myself built a few months back. https://www.pro-touring.com/forum/showthread.php?t=14726&highlight=buggy
It has a pretty much stock rebuilt 350 with about 50 miles on it...
4 bolt mains
stock rods
stock crank
hyper pistons
and 882 heads
so it's nothing special but is going to be a learning experience as well as something to toy around with.
To make it possible we have an 02 truck harness, coils, TB, and pcm.
Here is the plan:
For the Crank position sensor i took the reluctor ring? (don't know the name of it) off a junk ls1 crank I had which will be sanwiched between the harmonic balancer and crank pulley of the SBC. Then ill build a small bracket to hold the actual sensor.
For the Cam Position sensor i plan on cutting an LSx camshaft apart and fastening the part the sensor reads to an old dist. That way everything will be external and easily modified/removed/transplanted.
The only hard thing I see with those sensors will be getting them alligned perfectly where their supposed to read in the tdc position.
For the intake we were going to just modify a edelbrock air gap but have now decided to just fabricate a new aluminum intake manifold from scratch (might change as i am lazy lol)
From there the coil packs should be straight forward and the wiring will be next.
If anyone has a wiring diagram for an 02 truck harness it is greatly appreciated. ill have pics of the various parts soon.
Sorry for the long/unorganized post
Zach
It has a pretty much stock rebuilt 350 with about 50 miles on it...
4 bolt mains
stock rods
stock crank
hyper pistons
and 882 heads
so it's nothing special but is going to be a learning experience as well as something to toy around with.
To make it possible we have an 02 truck harness, coils, TB, and pcm.
Here is the plan:
For the Crank position sensor i took the reluctor ring? (don't know the name of it) off a junk ls1 crank I had which will be sanwiched between the harmonic balancer and crank pulley of the SBC. Then ill build a small bracket to hold the actual sensor.
For the Cam Position sensor i plan on cutting an LSx camshaft apart and fastening the part the sensor reads to an old dist. That way everything will be external and easily modified/removed/transplanted.
The only hard thing I see with those sensors will be getting them alligned perfectly where their supposed to read in the tdc position.
For the intake we were going to just modify a edelbrock air gap but have now decided to just fabricate a new aluminum intake manifold from scratch (might change as i am lazy lol)
From there the coil packs should be straight forward and the wiring will be next.
If anyone has a wiring diagram for an 02 truck harness it is greatly appreciated. ill have pics of the various parts soon.
Sorry for the long/unorganized post
Zach