80Camaro
08-12-2006, 01:30 PM
I got out there today and started cutting the first relief in my piston ( with the tool that goes into the valve guide of a bare head). After I finally got it cut down, the edges of the teeth were chipping really badly after ONE use!! I didn't even use a drill... I used a tap "T" handle and took my time with barely any pressure! And, the one they sent me for the intake side which is 2 1/4" just about goes to the edge of the piston. I didn't use it because I was afraid it would get the top edge of the cylinder.
Any experiences?
Any experiences?