View Full Version : Aeromotive weld in fuel sump for factory tank

07-14-2006, 05:59 PM
anyone using one? have pictures? i just got one in the mail today and it looks a little LARGE.. Ill will not know how it looks until i cut up my new tank.. thanks for any comments..

07-15-2006, 10:27 AM
I just received mine also. I am putting it into my 67 Lemans. Using a new factory tank for compatibility. Don't have any pictures yet. Will post when I do.

07-15-2006, 11:16 AM
I dont think im gonna use it.. i looked all over for for specs b4 i bought it. i have a 68 chevelle and i think it might look horrid hanging down as much a i think it will.. good luck with yours.. i would love to see some pictures.

07-15-2006, 12:09 PM
Maybe your not looking at it right, they look large out of the box. You have to cut the hole in the tank then set the sump up inside the tank, should only have a max of 4 inches sticking down but you can cut the top of the sump off more if you want it higher.

07-16-2006, 01:01 PM
yeah, im looking at how much will hang down from just above the return fitting. i used to run the competition engineering sump, which was much smaller but not as nice.. im gonna hang on to it and hopefully i can find a picture of one installed b4 i jump the gun. thanks for your comments..

07-19-2006, 12:16 PM
Hope to have mine welded up next month. Then I will paint it with POR-15.

07-19-2006, 05:56 PM
thanks, throw up some photos when you get it in..