Madspeed
06-14-2006, 04:59 PM
Heh well cup size is biggest I can fit, no gas lens yet
Postflow Is 10 to 12 secnods
I try my ass of to not to pull the rod out of shield
I have used L thinner to clean, I have tried from a shop rag to a rag that leaves no lint as well
The tube is .120 wall Cromolly and im set from 95 to actually 125 amps depending on if i am atatching to another tube or the frame
Flow If i remeber was around 25, Hmm you say to much can mess it up too eh?
Funny thing is some welds look awsome some look burnt
Oh and how big should the Heat ring be?
Pics bahh they came out all fuzzy ill redo tomorrow
here is one
Postflow Is 10 to 12 secnods
I try my ass of to not to pull the rod out of shield
I have used L thinner to clean, I have tried from a shop rag to a rag that leaves no lint as well
The tube is .120 wall Cromolly and im set from 95 to actually 125 amps depending on if i am atatching to another tube or the frame
Flow If i remeber was around 25, Hmm you say to much can mess it up too eh?
Funny thing is some welds look awsome some look burnt
Oh and how big should the Heat ring be?
Pics bahh they came out all fuzzy ill redo tomorrow
here is one