merlinpro69
06-04-2006, 10:21 AM
I did see a post a little while back as to set up the dist for efi...but I have a couple of ??'s. I do have the msd 2345 with adjust rotor.
I did do the 50* btdc, and centered the relutor to the pick-up...thats easy.
Now it says to roll the motor to about 30*, about max torque...ok, does that now make the mark @ 80* on the damper?
Is this where the cam sync is set up? And rotor?
Hope you guys can help as iv'e been getting some bad info...
I did do the 50* btdc, and centered the relutor to the pick-up...thats easy.
Now it says to roll the motor to about 30*, about max torque...ok, does that now make the mark @ 80* on the damper?
Is this where the cam sync is set up? And rotor?
Hope you guys can help as iv'e been getting some bad info...