classiccarcustoms
12-29-2024, 07:55 AM
Well this 6 year build, I am going to call 6 year wrap..
I just had the car wrapped here in St George UT. Turned out very nice. This is the first car I have had wrapped.
All the same prep work went into it as if I was going top paint it.
I did paint all the jams in a base coat clear to match the wrap exterior.
Let's get to the good parts!
-Speedtech extreme front chassis.
-Speedtech Extreme rear torque arm.
-Dutchbros full floating 9".
-DSE mini tubs.
-Speedtech frame brace kit.
-Wegner motor sports LS7.
-Holley engine management system.
-Ricks stainless gas tank.
-Stoptech front and rear brakes.
-JRI hydraulic ride control.
-Ringbrothers power window switch, hood hinges.
-GAS inner fender close out panels.
-Center console is 1 off custom made.
-Lower valence and air splitter is 1 off custom made.
-Dash pad is also one off custom made to appear stock, but not have that center gauge build,d out area.
-Forgeline wheels.
-JL audio, Focal speakers.
Just finishing up some little things now and should be on the track real soon.
The last picture is just a mock up stage on the RS front grill and headlight door adjustment. I spent 4 hours yesterday adjusting the gaps and fitment. I will post better pictures later today after I get the front bumper back on..
I just had the car wrapped here in St George UT. Turned out very nice. This is the first car I have had wrapped.
All the same prep work went into it as if I was going top paint it.
I did paint all the jams in a base coat clear to match the wrap exterior.
Let's get to the good parts!
-Speedtech extreme front chassis.
-Speedtech Extreme rear torque arm.
-Dutchbros full floating 9".
-DSE mini tubs.
-Speedtech frame brace kit.
-Wegner motor sports LS7.
-Holley engine management system.
-Ricks stainless gas tank.
-Stoptech front and rear brakes.
-JRI hydraulic ride control.
-Ringbrothers power window switch, hood hinges.
-GAS inner fender close out panels.
-Center console is 1 off custom made.
-Lower valence and air splitter is 1 off custom made.
-Dash pad is also one off custom made to appear stock, but not have that center gauge build,d out area.
-Forgeline wheels.
-JL audio, Focal speakers.
Just finishing up some little things now and should be on the track real soon.
The last picture is just a mock up stage on the RS front grill and headlight door adjustment. I spent 4 hours yesterday adjusting the gaps and fitment. I will post better pictures later today after I get the front bumper back on..