SoloC4
12-05-2023, 05:01 PM
As the title says, I installed the suspension from a 92 Corvette into my 84 Z28. There are many 3rd gens with the rear IRS, but this is the only one that has the front SLA also. All of the engineering, design, and fabrication was done by myself in half of a 2 car garage, no lift, or frame table. The front frame rails were sectioned and new rail inserts were installed at a 13 degree angle and a custom built K-member was fabricated in order to accommodate the LS engine and the Rack and Pinion from a 4th gen Camaro. Once the suspension was installed it was converted from transverse leaf springs to full coil-overs on all four corners. This was not an easy bolt in endeavor, but required a lot of custom fabrication and engineering. Like the saying goes if it was easy, then everyone would do it. This is truly a one of a kind build.21083021083821083721083621083521083421083321 0832210831210839