SBC 383, Piston to Valve clearance

[Just 1 More]

I know I'm going to get a lot of crap over this but... I have an e-bay engine, SBC 383, that came in the Factory Five 33 Hot Rod I just bought. It has never been run, never fired. With all the lifter failures, I pulled the intake to see if it has a hyd roller or flat tappet, and it's a flat tappet so I'm replacing with a roller. It has Chinesium aluminum heads and I don't really want to fall down the rabbit hole of pulling them. Not looking for big horsepower. Spec sheets says 9.9:1 comp so there is a dome. I'm looking at a Howards Retro fit Advertised Duration 278/284, Lift .500/.510. Anyone think there might be any piston to valve issues or should these specs be fine. Spec sheets says it has a .495 in it now. I know it's pure speculation but I also know a lot of you guys have experience building these 383 strokers so maybe you would have a good idea if I'm in the safe zone or not. On my BBC & Brodix heads 10.2:1 I'm running .601 lift with no issues but I'm unfamiliar with lift limits on mouse motors. Here's the spec sheet that was provided.
Thanks and please be gentle with me... LOL


204105