Blown353
05-21-2022, 01:26 PM
SOLD 10/26
Working on my car again and changing plans...
Selling a Vintage Air black anodized LS frontrunner setup with power steering, Vintage Air part number 174011. I'm changing to a Whipple 3.0 along with the matching Wegner accessory drive, so I don't need it anymore.
This has been partially mocked up on my car for several years now for determining clearance while doing fab work but never fully tightened down and never run as the engine is still unassembled. The things that might have been contacted during mockup were covered with blue painters tape and I had a moving blanket over the mocked up engine and frontrunner while doing any work, so nothing got messed up-- it's all in like-new condition. All hardware is bagged and labelled.
Only mod was I removed the 2x heater hose nipples from the water pump, as I was going to tap the water pump to install NPT-threaded AN fittings so I could easily run AN hoses to my turbos for cooling. You will need to tap the water pump housing and install your own NPT hose nipples for regular heater hose or AN fittings.
This kit originally came with the older 140A CS130 style alternator, I picked up the newer 170A mechman alternator for it a couple years ago. It's a direct bolt in substitution.
Also included is a tight-fit 90 degree AC compressor fitting kit, I needed it to clear my flipped 6.0 manifolds for the turbo setup.
Asking $2100. I would prefer to sell this locally and not have to ship it, but I am willing to split the shipping costs with a buyer. I'm near Lodi, CA and am willing to deliver or meet up half way within reason.
199940
200220
Working on my car again and changing plans...
Selling a Vintage Air black anodized LS frontrunner setup with power steering, Vintage Air part number 174011. I'm changing to a Whipple 3.0 along with the matching Wegner accessory drive, so I don't need it anymore.
This has been partially mocked up on my car for several years now for determining clearance while doing fab work but never fully tightened down and never run as the engine is still unassembled. The things that might have been contacted during mockup were covered with blue painters tape and I had a moving blanket over the mocked up engine and frontrunner while doing any work, so nothing got messed up-- it's all in like-new condition. All hardware is bagged and labelled.
Only mod was I removed the 2x heater hose nipples from the water pump, as I was going to tap the water pump to install NPT-threaded AN fittings so I could easily run AN hoses to my turbos for cooling. You will need to tap the water pump housing and install your own NPT hose nipples for regular heater hose or AN fittings.
This kit originally came with the older 140A CS130 style alternator, I picked up the newer 170A mechman alternator for it a couple years ago. It's a direct bolt in substitution.
Also included is a tight-fit 90 degree AC compressor fitting kit, I needed it to clear my flipped 6.0 manifolds for the turbo setup.
Asking $2100. I would prefer to sell this locally and not have to ship it, but I am willing to split the shipping costs with a buyer. I'm near Lodi, CA and am willing to deliver or meet up half way within reason.
199940
200220