kryptik
07-15-2021, 04:02 PM
Hi all,
I am looking for help to determine a fair market price for the below engine:
Background: I purchased a 1970 Chevrolet Camaro and this motor came with the car. The owner had a shop build it for high performance street. I don't have the paperwork for it anymore. Based on the block number, it is a later model 1986 SBC w/ 4-bolt mains. I later took the oil pan off to verify the internals--to my knowledge the entire lower end is forged quality stuff. I also replaced the intake manifold with a port injection setup as part of a school project to get it to run off of methanol--here is the video of the successful first startup (don't mind the tune, the motor itself runs well): https://youtu.be/ZyxcOvniVqU
(https://youtu.be/ZyxcOvniVqU)Here are the specs as far as I understand them:
1986+ SBC 4-Bolt Main w/ 1-piece rear main seal
Forged Rotating Assembly (name brand, but I forget the brand) including H-Beam Rods
Moroso Deep Oil Pan
AFR Aluminum Heads
Roller Lifters and Rockers
High Performance Street Cam
Edelbrock Tunnel Ram Port Injection Manifold (port-matched to gasket and heads)
Edelbrock Throttle Body
Runs on 91 Pump Gas
Fuel Injectors/Rails not included.
I've put pictures of the engine below.
I am looking to sell the engine because I am (G-d willing) moving to another state, and don't want to deal with transporting it.
Can anyone please help me to get a ballpark valuation that would be fair to the buyer and seller?
Thanks,
Moshe
19042219043019042919042819042719042619042519042419 0423190431
I am looking for help to determine a fair market price for the below engine:
Background: I purchased a 1970 Chevrolet Camaro and this motor came with the car. The owner had a shop build it for high performance street. I don't have the paperwork for it anymore. Based on the block number, it is a later model 1986 SBC w/ 4-bolt mains. I later took the oil pan off to verify the internals--to my knowledge the entire lower end is forged quality stuff. I also replaced the intake manifold with a port injection setup as part of a school project to get it to run off of methanol--here is the video of the successful first startup (don't mind the tune, the motor itself runs well): https://youtu.be/ZyxcOvniVqU
(https://youtu.be/ZyxcOvniVqU)Here are the specs as far as I understand them:
1986+ SBC 4-Bolt Main w/ 1-piece rear main seal
Forged Rotating Assembly (name brand, but I forget the brand) including H-Beam Rods
Moroso Deep Oil Pan
AFR Aluminum Heads
Roller Lifters and Rockers
High Performance Street Cam
Edelbrock Tunnel Ram Port Injection Manifold (port-matched to gasket and heads)
Edelbrock Throttle Body
Runs on 91 Pump Gas
Fuel Injectors/Rails not included.
I've put pictures of the engine below.
I am looking to sell the engine because I am (G-d willing) moving to another state, and don't want to deal with transporting it.
Can anyone please help me to get a ballpark valuation that would be fair to the buyer and seller?
Thanks,
Moshe
19042219043019042919042819042719042619042519042419 0423190431