PDA

View Full Version : Stainless Works Headers and S&P Mounts



Phillip_L
12-27-2005, 01:32 PM
Does the Stainless Works LS1 headers work with S&P mounts? I know they are suppose to work with BRP mounts, but I would like to use the S&P mounts. Has anyone tried it? I have a Unisteer rack and pinion (rear steer).

Phillip

Ralph LoGrasso
12-27-2005, 04:24 PM
Philip,

If no one is able to answer, you might send Alstainlessworks (https://www.pro-touring.com/forum/member.php?u=2729) a PM. He's a sponsor here, and I'm sure he'd know the answer.

Steve68
12-28-2005, 04:10 AM
Phil, Check LS1TECH.com go to the conversion and hybrids fourm and do a search, there's been alot of diffrent combo's there, also ask Al, he's alot of help, and quick on the reply, Steve

Phillip_L
12-28-2005, 06:25 AM
I sent a PM and I have called them. We will see. When I talked to Stainless Works, they were not sure if it would work. They did say they would let me return the headers if it did not work.

Phillip

datsbad
01-07-2006, 07:23 PM
This is what i am using . It works with minor adjusting

Phillip_L
01-11-2006, 06:57 PM
What do you consider minor?

Thanks,

Phillip

datsbad
01-11-2006, 07:13 PM
THE STEERING ARM ON THE PASS SIDE IS VERY CLOSE. I NEED TO DO A LITTLE MODIFING TO IT . I would definately buy there products again . very nice !