Log in

View Full Version : DSE Spec Moser Axles 9”


badazz81z28
08-23-2019, 01:36 PM
- Moser axles spec’d out for Detroit Speed 70-81 F-body 9” housing.
- 31 Spline
- Designed for an overall width of 56.250” flange to flange or 51.250” housing end to housing end (2.5" offset)
- Includes 3.25” screw in 1/2 ARP studs with black lug nuts
- Drilled access hole
- Includes tapered bearings

As measured from the back side of the flange.

#1 axle is approx 29-3/8"
#2 axle is approx 25-3/8"

The axle flange appears to be around 7/16". For face of flange to end of axle, add 7/16" inch.
DSEs price just for the axles is $515

Asking $300 shipped.
C Presley
10-25-2019, 05:53 PM
You still have the axles for sale? 408 644 4610
badazz81z28
10-26-2019, 07:13 PM
You still have the axles for sale? 408 644 4610


yes I do...
C Presley
10-26-2019, 08:21 PM
Any idea what shipping would be to Bay Area 95124 zip code
badazz81z28
10-27-2019, 05:57 AM
I would guess $50
badazz81z28
11-28-2019, 02:56 PM
Still for sale!
DKz Garage
11-28-2019, 09:08 PM
Still for sale!

Will these fit "Torino" ends, I assume 5 x 4.75 bolt pattern? Have these been used/installed in car?

Thanks in advance. Dave
badazz81z28
11-29-2019, 09:11 AM
Will these fit "Torino" ends, I assume 5 x 4.75 bolt pattern? Have these been used/installed in car?

Thanks in advance. Dave

Yes, these are for Torino Ends. Chevy Bolt Pattern w/screw in 1/2" studs. These have been used in the car. I pulled them because I installed a floater in the Camaro. These were cut for a 56.250" flange to flange axle set-up.
badazz81z28
11-30-2019, 07:59 AM
As measured from the back side of the flange.

#1 axle is approx 29-3/8"
#2 axle is approx 25-3/8"

The axle flange appears to be around 7/16". For face of flange to end of axle, add 7/16" inch.
badazz81z28
12-13-2019, 12:30 PM
Still For Sale
DKz Garage
12-23-2019, 12:25 PM
Just sent you a PM