classiccarcustoms
02-12-2019, 12:00 PM
161432161433161430161431I have a 1969 camaro stock frame that was sent out and sand blasted and powder coated.
Then added new:
-Ridetech stage 2, tubular upper and lower a-arms.
-Ridetech HQ coil overs.
-All new steering(inner and outer tire rods, center link, idler and pitman arms).
-After market 12:1 close ratio steering box.
-Hotchkis 1-1/8 sway bar.
-Ridetch drop spindles.
Baer 14" pro plus 6 piston disk brake kit. Black calipers and drilled rotors.
This whole set up only has maybe 200 miles on it. But car was at the body shop for a year. So has a couple scratches and is a little dirty from body shop dust.
Asking $4,000.
Location San Jose CA
I had to remove steering box and brake rotors and calipers to get clearance out of car. This is complete. Roller wheels not included.
I will bolt gear box and brakes back on.
Then added new:
-Ridetech stage 2, tubular upper and lower a-arms.
-Ridetech HQ coil overs.
-All new steering(inner and outer tire rods, center link, idler and pitman arms).
-After market 12:1 close ratio steering box.
-Hotchkis 1-1/8 sway bar.
-Ridetch drop spindles.
Baer 14" pro plus 6 piston disk brake kit. Black calipers and drilled rotors.
This whole set up only has maybe 200 miles on it. But car was at the body shop for a year. So has a couple scratches and is a little dirty from body shop dust.
Asking $4,000.
Location San Jose CA
I had to remove steering box and brake rotors and calipers to get clearance out of car. This is complete. Roller wheels not included.
I will bolt gear box and brakes back on.